Replacing a water heater in San Antonio with the same type and size, in the same spot, qualifies for the city’s Limited Service and Repair (LSR) permit: a licensed plumber does the work, then pulls the permit within 3 working days. Tank to tankless, or gas to electric, needs a regular permit. A typical tank swap runs $826 to $2,048 (handoff.ai, 2026).
Updated September 2026. Written by Jim Rodela, Texas Master Plumber M-44546.
Key facts
- LSR permit: covers “replacement of an existing water heater connected to an existing venting system, gas and/or electric circuit in the same location” (DSD Information Bulletin 121c, revised August 4, 2026).
- Timing: the licensed contractor obtains the LSR permit within 3 working days after finishing the work, to avoid a penalty fee (IB 121c).
- Excluded from LSR: tank to tankless, tankless to tank, electric to gas, gas to electric, relocations, new piping, and plumbing work generally valued over $2,000 (IB 121c).
- Tank replacement, San Antonio: $826 to $2,048 per unit, materials and labor including removal of the old unit (handoff.ai, 2026).
- Hard water: SAWS water typically runs 15 to 20 grains per gallon of hardness (SAWS water quality FAQ).
Which permit does your water heater need?
San Antonio’s Development Services Department (DSD) splits water heater jobs into two paths.
| Your job | Permit path | Inspection |
|---|---|---|
| Same type, same size, same location, existing vent and gas or electric circuit | LSR permit, pulled within 3 working days after the work | Contractor signs off; owner may request a DSD inspection |
| Tank to tankless, or tankless to tank | Regular plumbing permit | DSD inspection required |
| Electric to gas, or gas to electric | Regular plumbing permit | DSD inspection required |
| Moving the water heater to a new location | Regular plumbing permit | DSD inspection required |
| New gas piping or upgraded piping needed | Regular plumbing permit | DSD inspection required |
Source: IB 121c.
How the LSR permit works, step by step
- The licensed plumber replaces the heater. Same type, same place, existing vent and gas or electric supply.
- The plumber pulls the LSR permit within 3 working days of finishing.
- DSD notifies you in writing that the permit was issued and the licensed contractor states the work complies with the San Antonio Code.
- You choose. Accept the work as the contractor signed it off, or request a DSD inspection within 30 days of that notice, at no additional cost to you. You arrange access for the inspector.
- If something existing is not to code, the plumber marks “inspection needed” and a DSD inspection is triggered.
- DSD closes the permit 30 days after issue, or after the inspection.
This is why a same-day water heater swap is possible in San Antonio. We have replaced a leaking water heater the same day a customer found the leak.
What a water heater replacement costs
Typical San Antonio market range — not our quote. These figures come from public sources. They are here so you can sanity-check a quote, not to set ours.
| Job | Typical range | Source |
|---|---|---|
| Tank water heater replacement | $826 – $2,048 | handoff.ai, San Antonio (2026) (neutral) |
| Tankless water heater installation | $3,500 – $8,000; average ~$5,200 | Shafer Services Plus (2024) (competitor blog) |
| Gas line work added to a tankless conversion | ~$1,500+ | Shafer Services Plus (competitor blog) |
The tankless figures are a second-tier source: a San Antonio home-services company’s own blog, published in 2024. Use them as a rough guide only. We could not find a neutral San Antonio tankless figure we trust.
What moves the number
- Tank vs tankless. A tank swap is usually a like-for-like job. A tankless conversion often means new venting, a new gas line size, and a regular permit.
- Gas capacity. A gas tankless unit can need a bigger gas line than the old tank. Some homes need higher delivery pressure from CPS Energy, which requires a licensed contractor to check pipe sizing first. See our gas line cost guide.
- Location. Attic, closet and garage installs differ in access, drain pans and venting. We have swapped a Rheem tank inside a closet.
- Code updates. An older install that is not to current code gets brought up to code as part of the job.
Tank or tankless in San Antonio?
| Tank | Tankless | |
|---|---|---|
| Upfront cost | Lower (see table above) | Higher (see table above) |
| Permit path | Often LSR if like-for-like | Regular permit when converting from a tank |
| Hot water supply | Limited by tank size | Continuous, limited by flow rate |
| Space | Needs a closet, garage or attic spot | Wall-mounted, small |
| Hard water care | Flush sediment from the tank | Descale the heat exchanger |
We install both. We have converted a tank to a Rinnai tankless for a customer, and we handle the gas and venting side of that conversion ourselves because gas is one of our specialties.
How San Antonio hard water affects your water heater
SAWS says its water typically runs 15 to 20 grains per gallon of hardness, from sources including the Edwards Aquifer. That is very hard water. In a water heater, the minerals come out of solution as the water heats up:
- Tanks collect sediment on the bottom. Sediment insulates the water from the burner or element, so the heater works harder and gets noisy (a popping or rumbling sound).
- Tankless units build scale inside the heat exchanger, which cuts flow and efficiency.
- Valves and fittings scale up, including the temperature and pressure relief valve.
What helps: flushing a tank, descaling a tankless unit on a schedule, and treating the water before it reaches the heater. A water softener replacement, or a new softener in a pre-plumbed home, can also go on an LSR permit. Read our hard water guide or see water softeners and filtration.
Signs it is time to replace
- Water around the base of the tank
- Rusty or discolored hot water
- Popping or rumbling from the tank
- Running out of hot water faster than before
- A relief valve that drips or has been replaced more than once
A leaking tank is the urgent one. Shut off the cold water supply to the heater and turn off the gas or the breaker, then call.
When to call a plumber
In San Antonio, water heater replacement is permitted work for a licensed plumber. Gas water heaters also mean gas connections and venting, which should never be a DIY job.
We quote a flat price before work starts, and the permit is part of the job. Our work carries a 1-year warranty on parts and labor; if you supply the heater yourself, we cover our workmanship. See water heater installation, our pricing page, or call (210) 753-2290. Hours are Monday to Friday 8am to 5pm, with emergency service after hours. A flooding tank at night is what emergency plumbing is for.
Jim Rodela holds Texas Master Plumber license M-44546; verify it on the TSBPE licensee list.
Sources
- City of San Antonio DSD, Information Bulletin 121c, LSR permits (revised August 4, 2026): https://docsonline.sanantonio.gov/FileUploads/dsd/IB121c.pdf
- handoff.ai, replace hot water heater, San Antonio TX (2026): https://www.handoff.ai/construction-costs/replace-hot-water-heater/san-antonio-tx
- Shafer Services Plus, tankless installation cost in San Antonio (2024, competitor blog): https://shaferservices.com/how-much-does-it-cost-to-install-a-tankless-water-heater-in-san-antonio/
- SAWS, water quality FAQs: https://www.saws.org/your-water/water-quality/saws-water-quality-concerns/faqs/
- CPS Energy, Gas Service Standards: https://www.cpsenergy.com/content/dam/corporate/en/Documents/Gas_Service_Standards_CPSEnergy.pdf
- TSBPE, licensee list: https://tsbpe.texas.gov/free-licensee-list/





