In San Antonio, a new gas line typically runs $15.04 to $27.92 per linear foot, with an average job near $2,700, according to handoff.ai’s 2026 San Antonio cost data. Your number depends on the run length, the pipe material, trenching, whether the system needs more pressure, and the city permit and inspection.
Updated September 2026. Written by Jim Rodela, Texas Master Plumber M-44546.
Key facts
- Per foot, San Antonio: $15.04 to $27.92 per linear foot (handoff.ai, San Antonio, updated 2026).
- Average job, San Antonio: about $2,700 (same source).
- National context: national cost guides put gas line work at roughly $15 to $50+ per foot (Angi, HomeGuide).
- Permit required: a licensed plumber pulls a gas permit from the City of San Antonio before the work (DSD plumbing permits).
- Gas back on: CPS Energy restores service after the city releases the job, at (210) 353-2222 (CPS Energy Gas Service Standards §101.3).
Typical gas line costs in San Antonio
Typical San Antonio market range — not our quote. These numbers come from public cost guides. They help you sanity-check a quote. They are not what Pocket Plumber charges, and your job may land outside them.
| Measure | Typical range | Area | Source |
|---|---|---|---|
| New gas line, per linear foot | $15.04 – $27.92 | San Antonio | handoff.ai (2026) |
| New gas line, average job | ~$2,700 | San Antonio | handoff.ai (2026) |
| Gas line work, per foot | ~$15 – $50+ | National | Angi, HomeGuide |
A quick way to read the per-foot number
Per-foot figures are easy to misread. Here is the handoff.ai range applied to three run lengths. This is plain arithmetic on the published range, not a quote.
| Run length | Low ($15.04/ft) | High ($27.92/ft) |
|---|---|---|
| 20 ft (range or dryer near the meter side) | $301 | $558 |
| 50 ft (across the house) | $752 | $1,396 |
| 100 ft (outdoor kitchen, pool heater, detached shop) | $1,504 | $2,792 |
Notice that the average job (~$2,700) sits above most of these. The per-foot number covers pipe and installation. A real job also carries the items below.
What raises the cost of a gas line
1. Distance and route
Longer runs need more pipe, and often a bigger pipe size. Gas pipe is sized for the total appliance load and the length of the run. A 100-foot run to a pool heater can need a larger diameter than a short run to a dryer. Routes through a finished attic, around a slab, or under a deck take more labor than an open garage wall.
2. CSST vs black iron
Two common materials show up on San Antonio jobs:
- Black iron (rigid steel): threaded, durable, and labor-heavy to cut and fit. CPS Energy’s standard delivery for rigid steel and polyethylene piping is 4 oz (7 inches water column).
- CSST (corrugated stainless steel tubing): flexible, faster to route through walls and attics, and often cheaper in labor. CPS Energy allows 2 psig delivery for CSST systems, with a regulator the customer installs downstream (Gas Service Standards §201).
handoff.ai also lists copper as a material option. The right choice depends on the route, the load, and code, not just the lowest bid.
3. Trenching
Outdoor kitchens, fire pits, pool heaters and generators usually mean buried pipe. Trenching adds digging, bedding, and restoration of the yard or hardscape. Under CPS Energy’s standards (§603), buried piping stays exposed until inspected, so the trench stays open for the inspection before it is backfilled. Plan for that in your schedule.
4. A pressure upgrade
Adding a large appliance, such as a tankless water heater or a whole-home generator, can push a system past what the existing pipe and meter can supply. Raising delivery pressure requires a licensed plumbing contractor to check the pipe sizing and a pressure test documented to CPS Energy (§203). That work adds labor and coordination time.
5. Permit and inspection
Every new gas line in San Antonio needs a permit, a pressure test, and a city inspection before CPS Energy turns the gas on. That is time on the job and a permit fee from the city. See our gas line permit guide for the full sequence.
6. Repairs to what is already there
Older homes sometimes surprise you. If the existing piping has a leak, a failed test, or undersized sections, those repairs come before a new branch can be added. We tell you before any work starts.
Common jobs that need a new gas line
- Moving a range to a kitchen island during a kitchen remodel
- Converting an electric dryer or range to gas (gas appliance hookup)
- Outdoor kitchens, grills and fire pits
- Pool and spa heaters
- Standby generators
- Tank to tankless water heater conversions (water heaters)
How our flat-rate quote works
Pocket Plumber does not publish a price list, because two gas lines of the same length can be very different jobs. Here is what we do instead:
- We look at the job. Load, route, material, trenching, and meter capacity.
- We give you one flat price before work starts. No hourly meter running while we work.
- The quote covers the plan. Permit, pressure test and inspection steps are part of the plan, not an add-on after the fact.
- You decide. If the number does not work for you, you have lost nothing.
Our work carries a 1-year warranty on parts and labor. Parts you supply yourself are covered for workmanship only. Read more on our pricing page.
Jim Rodela holds Texas Master Plumber license M-44546 and is the Responsible Master Plumber for Pocket Plumber LLC. You can verify it on the TSBPE licensee list. A master license covers natural gas piping (TSBPE).
When to call a plumber
Call before you buy the appliance, not after. The line size and meter capacity can change which appliance makes sense. Call right away if you smell gas; leave the house first and follow our smell gas guide.
For a flat-rate quote on a new line, see gas line installation or call (210) 753-2290, Monday to Friday 8am to 5pm, with emergency service after hours.
Sources
- handoff.ai, gas line installation cost, San Antonio TX (updated 2026): https://www.handoff.ai/construction-costs/install-gas-line/san-antonio-tx
- Angi, average gas line repair and installation costs: https://www.angi.com/articles/average-gas-line-repair-and-installation-costs.htm
- HomeGuide, gas line installation cost: https://homeguide.com/costs/gas-line-installation-cost
- CPS Energy, Gas Service Standards (2021-03-15): https://www.cpsenergy.com/content/dam/corporate/en/Documents/Gas_Service_Standards_CPSEnergy.pdf
- City of San Antonio DSD, plumbing contractors: https://www.sa.gov/Directory/Departments/DSD/Contractor/Plumbing
- TSBPE, master plumber: https://tsbpe.texas.gov/license-types/master-plumber/
- TSBPE, licensee list: https://tsbpe.texas.gov/free-licensee-list/





